Return to BSD News archive
Newsgroups: comp.unix.bsd Path: sserve!manuel.anu.edu.au!munnari.oz.au!sgiblab!zaphod.mps.ohio-state.edu!cs.utexas.edu!uunet!sci34hub!gary From: gary@sci34hub.sci.com (Gary Heston) Subject: Re: How do I set ram location on wd8003e ? Message-ID: <1992Nov4.205044.5570@sci34hub.sci.com> Reply-To: gary@sci34hub.sci.com (Gary Heston) Organization: SCI Systems, Inc., Huntsville, Al. References: <1d7m0hINN2hf@iskut.ucs.ubc.ca> Date: Wed, 4 Nov 1992 20:50:44 GMT Lines: 19 In article <1d7m0hINN2hf@iskut.ucs.ubc.ca> admerlev@cipy.e-technik.uni-erlangen.de writes: >Hi, after shoveling around every bit of docs that I could access, >I dint find a way to tell my adaptor to use ram at d000 (Which >is the default for the bootimages). >Ezsetup doesnt work for the 8003e. >Any other way to get ftp/mount functioning over the network ? The memory address is determined by the driver code, in the case of the old (jumper-selected) WD8003E cards (I've got several around here, mostly in bridges). EZSETUP won't even recognize the card enough to report the settings... -- Gary Heston SCI Systems, Inc. gary@sci34hub.sci.com site admin The Chairman of the Board and the CFO speak for SCI. I'm neither. "...I looked out my window, and saw Kyle Pettys' car upside down, then I thought 'One of us is in real trouble'." Davey Allison, re: a 150MPH crash