Return to BSD News archive
Path: euryale.cc.adfa.oz.au!newshost.anu.edu.au!harbinger.cc.monash.edu.au!simtel!news.kei.com!hookup!noc.tor.hookup.net!alex From: alex@nnrp.tor.hookup.net (Alex Dumitru) Newsgroups: comp.unix.bsd.freebsd.misc Subject: Re: How to install Panasonic 562-J? Date: 18 Sep 1995 00:08:11 GMT Organization: HookUp Communication Corporation, Oakville, Ontario, CANADA Lines: 22 Message-ID: <43id9b$lvk@noc.tor.hookup.net> References: <43dh0u$a50@agate.berkeley.edu> NNTP-Posting-Host: netwaves.tor.hookup.net X-Newsreader: TIN [version 1.2 PL2] C.Y. Chiu (chiuc@volga.EECS.Berkeley.EDU) wrote: : I recently acquired a Panasonic 562-J cuz it was dirt cheap. I checked : to make sure that Panasonic 56x's are supported on FreeBSD, and I : compiled kernel with the following line: : controller matcd0 at isa? port ? bio : However, when I boot, it says: : matcd0: not found at 0xffffffff If you look in /sys/i386/isa/matcd in the file options.h there is an array called port_hints, that specifies where it will probe for the interface. If yours is not set for one of those, you'll be out of luck. Try setting your interface to 0x260... cheers alex -- alex@netwaves.com I don't trust camels... Actually, I don't trust anyone that can go a week without a drink.